What the camera name in jpeg's exif should looks like?

Discussion in 'C-GO2' started by lukfu, Dec 6, 2016.

Tags:
  1. luk

    lukfu New Member

    Joined:
    Oct 16, 2016
    Messages:
    11
    Likes Received:
    5
    As long as I try to update my CGO2+ with non-eu software, I still see (e) at the end of camera model in EXIF? Is it normal or my update procedurÄ™ wasn't sucesfull ???

    my exif says "CGO2gb 2.8.00(e)"
    after upgrading with this CGO2GB+ Firmware (Standard) 2.8.00/2.801 (http://yuneec-forum.com/resources/cgo2g ... ?update=18)

    am I doing it wrong ?
    of course I renamed file to 2.8.02 or so...
    upgrading procedure looks ok
     
    Tags:
  2. Jagerbomb52

    Jagerbomb52 Well-Known Member

    Joined:
    Jun 3, 2015
    Messages:
    4,443
    Likes Received:
    1,603
    Location:
    Kakabeka Falls Ontario Canada
  3. Jagerbomb52

    Jagerbomb52 Well-Known Member

    Joined:
    Jun 3, 2015
    Messages:
    4,443
    Likes Received:
    1,603
    Location:
    Kakabeka Falls Ontario Canada
    From what Yuneec tech guys have said in the past when ever you do firmware updates you have to rebind everything again to make a proper connection. So if you do this it might solve your problems:

    Turn Everything Off Bird and TX

    Turn on the ST10+ but not the bird

    After it initializes select Model. Select it at the bottom right of screen.

    Touch and Hold the model. Menu appears. Touch & DELETE.

    Now turn off ST10+

    Turn on the Bird. After it is on, Tilt forward from the back end 45 degrees two times to enter Bind Mode. Back light will start flashing Orange.

    Turn on ST10+ Select Flight Settings,at this time it will ask you to go to model select and create a new model. Once you have giving it a name click save and then Select Bind. Bind the Model and Bind the Camera

    Tap Return Button at bottom of ST10+ a few times to get back
     
Loading...

Share This Page

Loading...