Separate names with a comma.
Hello all, I haven't been active in a while but maintained my Chroma in perfect condition. Anyone know if I could use the ST10+ controlled with...
Selling my entire setup. - Yuneec Q500+ - 2 Sets of Propellors - OEM Yuneec 5400mah Battery still good, full flight time. - New (only one test...
This document is a compilation of MEMBER GENERATED INFORMATION. The accuracy of all information is limited to the observations and...
This document is a Chroma specific variation of the Q500 binding verification. It was developed as the first step in assisting a member that is...
Most cases of erratic behavior and unwanted bias in the ST10 Hardware Monitor are caused by contamination, corrosion or wear in the affected...
Hi Everyone! Just giving everybody some development updates. In the past few weeks i have been hard at work trying to crack the kernel. Finally i...
I've done several tests with the remote, drone is flying fine, CGO3 Wi-fi is ok because I can connect to it with my iPhone but I can't connect the...
Hi I have just bought an ST10+ off Ebay so that I have a controller to fit a 4Hawks/Itelite antenna The ST10+ has the Build number st10+v01b20c...
Long story short I bricked my original ST10+ controller that came with my Typhoon G, I bought another ST10+ but it came from a Typhoon with a CGo2...
Was given ST10+ it came with a Gimbal and MK58 video range extender from what I read about it. I have attached these items and added my GoPro...
When i use the left stick to yaw, it will have a very slow response compared to the right, as if the 'rabbit' is set to 'turtle' which it is not....
Newly purchased Blade Chroma with the ST10+. During almost every flight, the video on the ST10 will cut out - almost like the Android system...
So I was poking around Yuneec's site and if you go to Support | Downloads | Q500+ and then scroll down to the "Controller Firmware" section, it...
Hello! I have followed the boot screen modification tutorial and just changed my startup sound to something a little more subtle. That stock...
There are several that have done the Firmware Update from March 2016 for the ST10+ Controller. I have noticed since I had that my camera...
Hello everyboby! I purchased a Blade Chroma with ST10+ and GB203 gimbal (BLH8660). After a firmware update of the ST10+ to "ST10+v01b24c" and...
Hi! I have a question about assocation of st10 and cgo2+. I had crash with q500 almost a year ago and cgo2gb's mainboard breached. (I explained my...
Hi guys, I just got my ST10+ back from Carolina Dronz. Frank and the crew did my ITELITE antenna mod for me. And they did it very nice looking...
Hello, My Typhoon Q500+ decided to take a swim in the sea, and I never found it. I had it barely for 1 month. Now I have the ST 10+ ground...
Hi guys, I read somewhere that you could put a SD card in the ST10+ controller to log errors and possibly GPS coordinates. I opened my unit and...