C-GO3 CGO3+ Beep Codes

The beep codes indicate an issue with the camera's pitch encoder. There are a couple of possibilities. Which of the possibilities is the more likely depends on the recent history of the camera:

1.) If the camera has been in a crash:
a.) Look for damaged wires. Especially at the joint of the vertical and horizontal arms.
b.) Look for a damaged connector where the wires connect to the gimbal board.
c.) Look for loose wires at the encoder end.

2.) If the camera has been in storage for most of the time between the last time it worked and the first time the codes appeared, the problem is likely a degraded pitch encoder magnet. Refer to this document:
https://www.dropbox.com/s/uey586ndxx9dk3r/CGo3 series Tilt (Pitch) Magnet Replacement.pdf?dl=0
The magnets are hard to find. (They were not provided as a listed part.) They are most commonly obtained from scrap motors or by replacing the entire motor. Let us know if you need help locating a pitch encoder magnet.

 

This Ebay seller still seems to have some. I don't currently know of another source.
Yuneec C23/E90 Gimbal Camera Magnet Part | eBay