CGO3+ Steadygrip Project

Discussion in 'Steadygrip / Wizard' started by Sean Rudden, Dec 6, 2018.

  1. Sean Rudden

    Sean Rudden New Member

    Dec 5, 2018
    1
    0
    1
    Male
    Hello Yuneec enthusiasts, I have been looking to start a new project. I want to make a steadygrip fully compatible with the CGO3+, I was hoping I could buy the electronic innards of the CGO3 steadygrip, instead of ripping apart a new one, and 3d printing a handle that would allow more room for the CGO3+. After much searching, I could not find just the parts. I found this thread where they go into using an ATtiny and Arduino to communicate with the gimbal, but I don't like the method they use as it doesn't guarantee it will work. Even if I could get the information written on the chips inside the steadygrip, I could figure out what they do and possibly demystify what protocol all of the CGO gimbals use so I could write new code. Any help would be appreciated.
     
Loading...

Share This Page