ECU no beep and light flickers when turned on

Discussion in 'E-GO Skateboard' started by Erin McCormick, May 7, 2018.

  1. Erin McCormick

    Erin McCormick New Member

    May 7, 2018
    1
    0
    1
    Male
    I let my ego2 sit in the garage for about a month without using it and when I turned it on the ECU did not beep and then the light just flickers. I can hook it up to my remote no problem and it shows battery fully charged. I charged battery to make sure. The issue is that when I try to ride it will not go unless I push and same when I am not riding have to spin wheel to get it to move. I went so far as to buy another ECU and it did the same thing! I cant figure this out any help would be VERY appreciated!

    If not I will be likely parting out my board...
     
Loading...

Share This Page