Gimbal wiring from mounting plate to circuit board

Discussion in 'Help' started by Clinton H, Dec 16, 2016.

  1. Clinton H

    Clinton H New Member

    Dec 16, 2016
    1
    0
    1
    Male
    I have a Q500 4k and am very sorry but don't know much about it. I got it on trade with some damage.
    Looks like the rubber boots must have let go and torn the wires from the mounting plate off of the circuit board itself.

    Can a guy re-solder these back on? Anyone have a diagram of where they go? There's only 3 of them.
    Can a gimbal be purchased without a camera? Can i just buy the circuit board? Thanks and again I'm sorry if a search could find me an answer. I did try. 20161215_223847.jpg
     
Loading...

Share This Page

OK More information

This site uses cookies. With your click on OK, you agree to the use of cookies to. Otherwise is the functionality of this site limited.