ST10+ PLS HELP ME

Discussion in 'ST10(+) Controller' started by alper zorlu, Jul 9, 2019.

  1. alper zorlu

    alper zorlu New Member

    Jul 8, 2019
    2
    0
    1
    Male

    Attached Files:

  2. WTFDproject

    WTFDproject Active Member
    Staff Member

    Oct 3, 2018
    774
    97
    28
    Male
    Retired Power Plant
    North Carolina Piedmont
  3. alper zorlu

    alper zorlu New Member

    Jul 8, 2019
    2
    0
    1
    Male
    because I wanted to install a new update and reset it, then there was no more binding only the camera comes (drone) model does not come.ı think so there is no rf file in the firmware
     

    Attached Files:

  4. WTFDproject

    WTFDproject Active Member
    Staff Member

    Oct 3, 2018
    774
    97
    28
    Male
    Retired Power Plant
    North Carolina Piedmont
    It would be safer to identify the exact cause of the failure to bind the drone. The attached file was designed just for that purpose. I regret that it is very long, but the high detail was needed to capture all the subtle differences that can provide clues. Please read it exactly as written. Some earlier folks failed to perform some of the steps because "I've already done that". Take your time, take notes of abnormal responses, and we will have a good place to start researching the problem. One file is for the Q500 series, the other is for the Chroma. I am not sure which model drone you have, so I attached both.
     

    Attached Files:

    javier lopez vaamonde likes this.
Loading...

Share This Page