Programming Yuneec H520 ST16s for survey mission and gimbal calibration

Discussion in 'H520 Hexacopter' started by Jas, Sep 30, 2017.

  1. Jas

    Jas Administrator
    Staff Member

    Aug 3, 2017
    185
    35
    28
    Male
    Engineer
    Canada
    Seems very intuitive and easy to use. So who's got one already on this forum or planning on getting one? Please share your reviews and thoughts. If possible post video footage as well.



     
    Addison likes this.
  2. Ddraiggoch

    Ddraiggoch Member

    Mar 24, 2016
    48
    8
    8
    I tried out the windows version today.

    It works a treat, at least setting up a flight plan does.

    I had trouble getting the offline maps to download to the ST16S but that was due to a little cerebral flatulence as much as anything.

    They are in now but will be early next week before I have the chance to test the accuracy of them.
     
    Addison and Jas like this.
  3. Edward Meijer

    Edward Meijer Member

    Sep 28, 2016
    31
    1
    8
    Male
    I am just now trying to figure out how to set waypoints on my H520, I must be missing something.
    Anybody has done waypoint on the H520?
     
  4. Edward Meijer

    Edward Meijer Member

    Sep 28, 2016
    31
    1
    8
    Male
    OK Thanks so much for the info.
     
  5. Andrea_63

    Andrea_63 New Member

    Dec 23, 2017
    1
    0
    1
    Male
    Hi to all of you
    Can I change the height of a group of waypoints in survey mode ?
    This to mantain the GSD on a slope
    TIA
     
  6. BigA

    BigA New Member

    Jan 14, 2019
    19
    4
    3
    Male
    Try "Vehicle follows Terrain" down at the bottom right of screen dump. I have not used it but it seems likley.
    Data Plot Planner.jpg
     
  7. BigA

    BigA New Member

    Jan 14, 2019
    19
    4
    3
    Male
    I would like to know which software to use for stiching these files together. Some routines get confused because every alternate row is upside down due to the drone turning for the next row.
     
Loading...

Share This Page