Q500 Q500 bounce

The flight controller with it's sensors gyro, accelerometer and barometer. Except barometer all those components are on mainbord.

Change mainboard is too expensive for this oldtimer. Checking can be done in GUI and limited by flight logs.

Yuneec is out of consumer marked. Q500 is very old - no firmware update anymore since years. I think a final fix is only possible in firmware.


Aging sensors and temperature drift may be the cause when the behavior gets worse. You should do a accelerometer calibration. For Blade 350QX there was a temperature calibration procedure, for Q500 (nearly same sensors) I do not know such a procedure.

br HE