Semi Fly Away - Ascend Issue

Discussion in 'Typhoon H Discussion' started by AerialAnt, Jan 9, 2017.

  1. AerialAnt

    AerialAnt Member

    Dec 6, 2016
    62
    15
    8
    On my 2nd flight today I went straight up to about 200' and when I tried to descend the drone took almost 3 min to descend to 50'. From there on out anytime I hit full left throttle left stick up to climb it would remain climbing even if I went full down on left stick. The only way to break the climb was to make a maneuver with the right stick, which would then allowing the left stick input to function again. I reproduced this phenomenon multiple times in a row. This is a bit unnerving

    Does anyone have a clue what this is? Never had an issue before
     
  2. PatR

    PatR Moderator
    Staff Member

    Jan 10, 2016
    300
    100
    43
    Male
    Retired sUAS professional
    Central California
    What position was the speed slider in?
     
  3. AerialAnt

    AerialAnt Member

    Dec 6, 2016
    62
    15
    8
    It would do it with the slider in any position. I typically fly all the way up (rabbit) and land more towards turtle for control but in this case I was trying the slider in all manner of positions
     
  4. TheLazyC

    TheLazyC Member

    May 5, 2015
    45
    14
    8
    What mode were you flying in? If you were not in Angle mode, it is not going to land that close to you if it went straight up.
     
Loading...

Share This Page

OK More information

This site uses cookies. With your click on OK, you agree to the use of cookies to. Otherwise is the functionality of this site limited.