Yuneec chroma cgo2 no gps

Discussion in 'News' started by Skyrocket83, Sep 5, 2023.

  1. Skyrocket83

    Skyrocket83 New Member

    Sep 5, 2023
    2
    0
    1
    Male
    When I turn my drone on it goes beep .beep .duh. duh. And the white lights flash. But when I go to turn on GPS and calibrate it the compass the lights Turn green in front and red in the back for a few seconds then back to white and beeping again and it says GPS is disabled and mag failed.
     
  2. WTFDproject

    WTFDproject Well-Known Member
    Staff Member

    Oct 3, 2018
    1,079
    183
    63
    Male
    Retired Power Plant
    North Carolina Piedmont
    As recognized by @Pier2162, the symptoms you describe are consistent with GPS Module problems when seen on a Chroma.
    Several possibilities exist as source of the issue. It could be a failed module, damaged wiring from the module to the board, the module is unplugged, damage to the mainboard or possibly even corrupted firmware.
    Has anything happened between the last time the Chroma started normally and the first time it did not? Things like hard landings/crash, firmware updates, calibrations, long storage periods, or anything else you can think of.
    If there is no history that might suggest the specific issue, you may want to start by ensuring the GPS is plugged in and no corrosion is present on the contacts.
     
    Pier2162 likes this.
Loading...

Share This Page