yuneec typhoon q500 cgo2 gimbal wire

Discussion in 'General Discussion' started by I am yuneec, Jan 18, 2020.

  1. I am yuneec

    I am yuneec New Member

    Nov 15, 2019
    28
    0
    1
    Male
    Hi,I am trying to find out which of the ports on the wire with the 3 prong connector should have power.At the moment there is nothing,the other connector has power but the camera isn't powering up when it's connected.Would like to try and resolve this issue,any help appreciated.
     

    Attached Files:

  2. WTFDproject

    WTFDproject Active Member
    Staff Member

    Oct 3, 2018
    932
    138
    43
    Male
    Retired Power Plant
    North Carolina Piedmont
    #2 WTFDproject, Jan 19, 2020
    Last edited: Jan 19, 2020
    These drawings may help.
    Please understand the 3 prong connector is NOT power. It is a very low voltage PWM signal for controlling camera tilt. If you try to put battery voltage to it, you will likely ruin both camera and drone mainboard.
    CG02 Harness to Camera Wiring R4.jpg 350QX_Q500 + Camera Connector Wire.jpg
     
  3. I am yuneec

    I am yuneec New Member

    Nov 15, 2019
    28
    0
    1
    Male
    There must be an issue further on,I've inspected the motherboard and nothing seems to be wrong ( I am a novice at this).It did receive a voltage charge earlier that burnt out the little circuit board (was replaced) inside the drone where the gimbal adapter connects outside the body.
     
  4. WTFDproject

    WTFDproject Active Member
    Staff Member

    Oct 3, 2018
    932
    138
    43
    Male
    Retired Power Plant
    North Carolina Piedmont
    Yuneec did not provide the calibration software to anyone other than authorized service centers. Your camera will have to be shipped to one of the service centers for anything other than the camera calibration provided in the Q500 GUI.
    "https://www.yuneec.com/de_DE/support/downloads/typhoon-q500plus-de.html"
     
  5. I am yuneec

    I am yuneec New Member

    Nov 15, 2019
    28
    0
    1
    Male
    Hello,I dont know what that is,I'll think I'll be ok now.
     
Loading...

Share This Page